Earthquaker Devices Astral Destiny

Reverb Modes
Abyss: Huge reverb with no octave effect
Shimmer: Adds an upper octave to the reverb tail
Sub: Adds a lower octave to the reverb tail
Sub Shimmer: Adds an upper and lower octave to the reverb tail
Astral: Adds an upper and lower octave combined with a regenerating tail
Ascend: Upward pitch bending
Descend: Downward pitch bending
Cosmos: Adds a regenerating fifth to the reverb tail

Presets

The Astral Destiny operates between two different modes: Live or Preset. It comes with 8 factory presets, 1 for each reverb mode, that can be edited or completely overwritten for your enjoyment. The settings for Length, Depth, Rate, Tone, Mix as well as EXP assignment and Stretch length can all be stored and recalled. Any of the Astral Destiny’s 8 reverb modes can be used as the basis for each of the 8 presets.

Live Mode
This is the standard mode of operation that the Astral Destiny ships in and is indicated by a Green or Red Activate LED depending on the bypass state. Astral Destiny will operate manually in this mode and all controls will visually indicate the current settings.

Preset Mode
This puts the Astral Destiny into one of the 8 presets selected by the Preset rotary switch. This mode is indicated by a Yellow Activate LED. The panel controls will no longer operate as visually set and instead, the Astral Destiny will use the stored control settings for each selected preset position. If a control change is made while in Preset Mode, the Activate LED will begin to flash. You can easily save this change by holding down both footswitches until both LED’s flash 4 times indicating that the change has been saved.